Demonstration store. Orders are recorded but nothing is charged, shipped, or emailed.
Dual-action polisher and foam pads on a workshop mat

Backing Plates

Backing Plates

The backing plate is a safety part. It must match the machine’s thread and throw, and it should be roughly 20–25 mm smaller than the pad so the pad’s edge is supported. A worn plate with a lifting hook-and-loop face will throw a pad at speed.

Filtered by Out of stock Remove filter Clear all

0 products

No product matches every filter at once. Clear the filters

No products were found matching your selection.

Choosing Backing Plates

The backing plate is a safety part. It must match the machine’s thread and throw, and it should be roughly 20–25 mm smaller than the pad so the pad’s edge is supported. A worn plate with a lifting hook-and-loop face will throw a pad at speed.